View Single Post
Old 04-19-2021, 06:34 PM   #5
WetSocks
 
Join Date: Apr 2021
Location: NH
Posts: 5
Vehicle: 1997 Hardbody 4x4
Thanks: 1
Thanked 1 Time in 1 Post
Default

That is the tool I've been using. Had pop off a couple times with the force that it was applying to the spindle.

I finally separated the joint from the knuckle. Lots of heat, hammering and pressing. Came very slowly.

Looks like I'm going to have to pull the axle, there is nowhere near enough room to get this bj out of the knuckle.
WetSocks is offline   Reply With Quote