View Single Post
Old 04-07-2021, 04:42 AM   #3
chrismtb
 
chrismtb's Avatar
 
Join Date: Jul 2016
Location: San Diego
Posts: 11
Vehicle: 1988 D21 4x4 SEV6
Thanks: 0
Thanked 4 Times in 2 Posts
Default

I don't think I worded my question clearly enough.
I am not expecting both high+low to be on at the same time. When I'm in the low beam position, only the passenger side low beam comes on (driver side is completely off). When I'm in the high beam position, only the driver side high beam comes on (passenger side is completely off).

I have tested with the harnesses pulled out with the bulbs hanging loose and swapped them back and forth. The problem is the same regardless of switching the bulbs, re-seating the harness, and jiggling the connections.

As you mentioned, I suspect it's probably the stalk. It just seems odd that the voltages are correct, at least without a load. I do appreciate the comment on the inexpensive part being adequate.
chrismtb is offline   Reply With Quote