Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.09 seconds.
Search: Posts Made By: alabama_lowlife
Forum: Engine and Drivetrain Yesterday, 02:16 PM
Replies: 8
Views: 33
Posted By alabama_lowlife
This thread should cover a lot of questions....

This thread should cover a lot of questions. http://www.infamousnissan.com/forum/showthread.php?t=33711
Forum: Introductions Yesterday, 02:15 PM
Replies: 1
Views: 14
Posted By alabama_lowlife
Welcome to infamous Nissan!

Welcome to infamous Nissan!
Forum: Hardbody Forum (D21) Yesterday, 10:14 AM
Replies: 82
Views: 838
Posted By alabama_lowlife
It should be 34 psi at idle and 43 when it’s not...

It should be 34 psi at idle and 43 when it’s not running. Next step is to use a hand held vacuum pump connected to the FPR. Fuel pressure should drop when you increase vacuum. If it doesn’t, the fpr...
Forum: Hardbody Forum (D21) Yesterday, 10:09 AM
Replies: 2
Views: 24
Posted By alabama_lowlife
It should not be leaking there (obviously) but I...

It should not be leaking there (obviously) but I don’t think it’s an indication of a larger issue. There is a vent tube on the side of the transmission. If there was not a tie wrap at the base of the...
Forum: Introductions 08-15-2022, 05:26 PM
Replies: 7
Views: 48
Posted By alabama_lowlife
Welcome to infamous Nissan!

Welcome to infamous Nissan!
Forum: Wiring and Electrical 08-15-2022, 10:17 AM
Replies: 1
Views: 31
Posted By alabama_lowlife
I don’t have time to dig up any pics before work,...

I don’t have time to dig up any pics before work, but here’s the applicable wiring diagram for the 94. https://www.nicoclub.com/service-manual?fsm_download=Hardbody/1994/EL.pdf
Forum: Introductions 08-15-2022, 10:13 AM
Replies: 3
Views: 34
Posted By alabama_lowlife
Welcome to infamous Nissan!

Welcome to infamous Nissan!
Forum: Wiring and Electrical 08-13-2022, 12:32 PM
Replies: 6
Views: 72
Posted By alabama_lowlife
Sounds like loose/corroded connections of the...

Sounds like loose/corroded connections of the fusible links or battery.
Forum: Engine and Drivetrain 08-12-2022, 12:48 AM
Replies: 5
Views: 35
Posted By alabama_lowlife
It’s not the speed sensor that is in the...

It’s not the speed sensor that is in the transmission for the speedometer.

There is a speed sensor on the rear differential for the ABS system. But there is a troubleshooting procedure in the FSM...
Forum: Engine and Drivetrain 08-11-2022, 11:02 PM
Replies: 5
Views: 35
Posted By alabama_lowlife
Check the brake fluid level.

Check the brake fluid level.
Forum: Hardbody Forum (D21) 08-10-2022, 02:24 PM
Replies: 20
Views: 232
Posted By alabama_lowlife
I just use Permatex ultra black

I just use Permatex ultra black
Forum: Hardbody Forum (D21) 08-09-2022, 12:55 PM
Replies: 20
Views: 232
Posted By alabama_lowlife
I’ve always added RTV to the half moons.

I’ve always added RTV to the half moons.
Forum: Introductions 08-08-2022, 12:50 AM
Replies: 8
Views: 83
Posted By alabama_lowlife
Welcome to infamous Nissan!

Welcome to infamous Nissan!
Forum: Hardbody Forum (D21) 08-07-2022, 04:10 PM
Replies: 82
Views: 838
Posted By alabama_lowlife
Shit man, I don’t know what’s wrong but that...

Shit man, I don’t know what’s wrong but that sounds awful. Is the loudest noise from the exhaust? Other than the cat being gone is the exhaust complete?
Forum: Nissan SUV 08-07-2022, 03:53 AM
Replies: 3
Views: 108
Posted By alabama_lowlife
I still want another pathfinder. Actually, I...

I still want another pathfinder. Actually, I really want 3-4 lol
Forum: Hardbody Forum (D21) 08-07-2022, 02:43 AM
Replies: 7
Views: 99
Posted By alabama_lowlife
Welcome to infamous Nissan. I suspect the roll...

Welcome to infamous Nissan. I suspect the roll bar for any minitruck will fit with minor work. The brush guard is a different story. I’d guess you could get one from another truck to work but you’d...
Forum: Hardbody Forum (D21) 08-05-2022, 10:19 AM
Replies: 2
Views: 40
Posted By alabama_lowlife
With it running so poorly it will be damn near...

With it running so poorly it will be damn near impossible to check the timing with a timing light. Make sure the distributor rotor didn’t come loose. Set the engine to TDC on the compression stroke...
Forum: Hardbody Forum (D21) 08-03-2022, 10:18 AM
Replies: 82
Views: 838
Posted By alabama_lowlife
Replace the o-rings on the injectors.

Replace the o-rings on the injectors.
Forum: Hardbody Forum (D21) 08-03-2022, 10:15 AM
Replies: 11
Views: 157
Posted By alabama_lowlife
Go back to my first post and check the voltages.

Go back to my first post and check the voltages.
Forum: Hardbody Forum (D21) 08-02-2022, 08:57 PM
Replies: 82
Views: 838
Posted By alabama_lowlife
Smoke of any color should not be leaking around...

Smoke of any color should not be leaking around the spark plugs. Burning oil is typically blue smoke. Which is what would be burning due to bad rings or valve seals. I’d replace the washers on the...
Forum: Hardbody Forum (D21) 08-02-2022, 10:17 AM
Replies: 11
Views: 157
Posted By alabama_lowlife
What anti theft? Aftermarket? If you’re getting...

What anti theft? Aftermarket? If you’re getting 12vdc from the black/yellow wire you should have 12vdc at the relay. If it’s passing through an aftermarket anti-theft system it may be your problem.
Forum: Hardbody Forum (D21) 08-01-2022, 10:13 AM
Replies: 20
Views: 252
Posted By alabama_lowlife
You also need to set the timing to 10 btdc with...

You also need to set the timing to 10 btdc with a timing light. This can’t be guessed at or approximated.
Forum: Hardbody Forum (D21) 08-01-2022, 01:26 AM
Replies: 11
Views: 157
Posted By alabama_lowlife
If voltage is NOT present, check the green...

If voltage is NOT present, check the green fusible link and the ignition switch. Check for 12vdc on the white/black wire on the ignition switch. It should always be present. Check for 12vdc on the...
Forum: Hardbody Forum (D21) 07-31-2022, 09:33 PM
Replies: 11
Views: 157
Posted By alabama_lowlife
It’s on the passenger side inner fender

It’s on the passenger side inner fender
Forum: Hardbody Forum (D21) 07-31-2022, 03:13 PM
Replies: 11
Views: 157
Posted By alabama_lowlife
With the ignition switch in the start position,...

With the ignition switch in the start position, check for 12vdc at the 2 Black/yellow wires on the interlock relay.

With the clutch pedal depressed, check for continuity to ground on the Light...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 01:06 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.