View Single Post
Old 03-21-2012, 02:33 PM   #1
alabama_lowlife
Owner and Administrator
 
alabama_lowlife's Avatar
 
Join Date: Sep 2008
Location: jack, alabama
Age: 41
Posts: 10,168
Vehicle: 2012 370Z, 1970 Datsun 521, 1995 Nissan Hardbody x2
Thanks: 911
Thanked 1,987 Times in 1,636 Posts
Default Ronnie's dash swap wiring how-to

http://www3.telus.net/ronnie/Gauge%2...Conversion.pdf

Lots of guys have been asking me about the hazard switch wiring. Here is an update to that wiring. This info is for 89 swapping to 97. If you find this doesn't work, let me know what year you have and I'll sort it out.

For the hazard switch plug, rewire it like this using your old wires and the old plug. Then plug it up to the new switch. Cut the plug off the wires. I list the loose wires first and the stub of wire sticking out of the plug as the plug pin color.



Connect the Green wire to the Brown/white plug pin

Connect the red/yellow wire to the gray/red plug pin

Connect the gray/blue wire to the gray/blue plug pin

Connect the gray/red wire to the pink/blue plug pin

Connect the pink/black wire to the white/black plug pin

Connect the pink/blue wire to the green plug pin

Connect the brown/white wire to the red/yellow plug pin

Connect the white/black wire to the pink/black plug pin
-----------------------------------------------------------------------------------------------

Ran into an issue today that I had not run across before while helping bradonodom18 work on his swap. The temperature gauge wiring it different on the non-tach trucks. His new cluster is from a 94 without a tach. The temperature gauge wire is C31 instead of A3 for the non-tach clusters.
alabama_lowlife is offline   Reply With Quote
Thanked by:
Baggedfullsize (09-23-2013)