View Single Post
Old 05-21-2013, 11:04 PM   #7
Tally HB
The Old Guy
 
Join Date: Feb 2013
Location: North Florida
Age: 57
Posts: 721
Vehicle: 1989 D21 Base 2WD 2.4L
Thanks: 23
Thanked 100 Times in 80 Posts
Default

Here is where I tapped into my cooling system to install the switch. I should have tapped into the t-stat housing because the cooled water, that leaves the radiator, never reaches a high enough temp to ground the switch at 195 degrees. I will change this later.

So, tap into your t-stat housing on the top above the thermostat. There is a flat spot with a "plug" there that will work just fine.









Where I should have tapped the switch


__________________
1989 D21 Standard Cab 4x2
2.4L Z24i, 5spd

Last edited by Tally HB; 05-28-2013 at 10:42 PM.
Tally HB is offline