View Single Post
Old 05-19-2013, 06:47 AM   #2
Tally HB
The Old Guy
 
Join Date: Feb 2013
Location: North Florida
Age: 57
Posts: 721
Vehicle: 1989 D21 Base 2WD 2.4L
Thanks: 23
Thanked 100 Times in 80 Posts
Default

Here is a temporary parts and materials list. This will change as I progress through the install.




Parts needed:
- Cooling fan assembly from early Altima 2.4L engine
- 195 degree on, 175-170 degree off fan switch (Part #WT622P Borg Warner)
- Several feet each of heavy gauge (10ga ) wire in red, black and white
- Several feet each of small gauge wire in red, black and green
- Four 30 or 40 amp, five post relays (can be plucked from most any import car)
- One single throw panel rocker or toggle switch 12v (On/Off switch)
- Electrical connectors, spade connectors, butt splice connectors
- Electrical solder and soldering gun/iron
- Heat shrink tubing
- Black electrical tape
- Plastic conduit tube (for protection of wiring)

Tools needed:

- Basic metric socket set
- Basic metric wrench set
- Pliers and wire cutters
- Wire stripper/crimper tool
- Test light and/or multi meter
- Drill
- 11/32" drill bit
- 1/8" by 27 NPT tap (National Pipe Thread)
__________________
1989 D21 Standard Cab 4x2
2.4L Z24i, 5spd

Last edited by Tally HB; 05-28-2013 at 10:36 PM.
Tally HB is offline