View Single Post
Old 11-23-2016, 06:05 PM   #5
Reserector
the Flaming Marshmallow
 
Reserector's Avatar
 
Join Date: Oct 2015
Location: Laurel, MS
Posts: 1,456
Vehicle: Nissan HB KC 4x4
Thanks: 10
Thanked 339 Times in 268 Posts
Default

Quote:
Originally Posted by slo87 View Post
My truck is a 4cyl idk what difference that makes. Cv axles in my 4cyl can almost be removed without turning a bolt. What holds the CV axle within the hub end or is it supposed to slide 3 inches in and out?
The early 4 bangers had 28 spline axles, while the v6 had 30. After a few years, they went to 30 spline for all. The 28s are smaller diameter.

You should be able to measure the inside of the groove to determine the I.D and groove width. Armed with that knowledge, you can get them at a hardware store.

Last edited by Reserector; 11-23-2016 at 06:11 PM.
Reserector is offline   Reply With Quote