Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.02 seconds.
Search: Posts Made By: Cusser
Forum: Interior & Audio/Video Yesterday, 04:23 PM
Replies: 1
Views: 35
Posted By Cusser
https://www.seatcoversunlimited.com/

https://www.seatcoversunlimited.com/
Forum: Engine and Drivetrain 01-13-2021, 02:22 PM
Replies: 12
Views: 137
Posted By Cusser
Barbed radiator hose connectors are readily...

Barbed radiator hose connectors are readily available in parts stores, several common sizes.
Forum: Wiring and Electrical 01-12-2021, 02:14 PM
Replies: 6
Views: 88
Posted By Cusser
Same on my '98 and 2004 4-cylinder Frontiers. ...

Same on my '98 and 2004 4-cylinder Frontiers.


My '98 has a cable to the fender hump bolt, and a one from there to the engine block, because I didn't want to order one from a dealer. On my '98,...
Forum: Engine and Drivetrain 01-12-2021, 02:11 PM
Replies: 12
Views: 137
Posted By Cusser
Is a 30i water inlet still available, and if so...

Is a 30i water inlet still available, and if so could that work ???
Forum: Early Frontier Forum (D22) 01-10-2021, 03:17 PM
Replies: 8
Views: 1,229
Posted By Cusser
I would start your own thread for this.

I would start your own thread for this.
Forum: Engine and Drivetrain 01-10-2021, 03:14 PM
Replies: 12
Views: 137
Posted By Cusser
This. I remember doing just that when I needed a...

This. I remember doing just that when I needed a small U-shaped hose to block off the rear heater unit in an older Suburban.


From looking at that photo, you needed a molded hose, or maybe a...
Forum: Engine and Drivetrain 01-06-2021, 01:21 PM
Replies: 6
Views: 89
Posted By Cusser
Yes, I absolutely would get that real clean. ...

Yes, I absolutely would get that real clean. Maybe a wire brush on an electric drill or Dremel tool. Or buy a new PS pulley.

I don't know if you can remove that PS pulley without removing the PS...
Forum: Engine and Drivetrain 01-03-2021, 03:03 PM
Replies: 6
Views: 89
Posted By Cusser
Yep, same on my '98 and 2004 with 4-cylinder...

Yep, same on my '98 and 2004 with 4-cylinder engine. I've replaced the PS idler and AC idler (different diameter and part number) on both when the bearings locked up and burned the belt or made...
Forum: Engine and Drivetrain 01-02-2021, 03:14 PM
Replies: 1
Views: 72
Posted By Cusser
When I was working, we even came across...

When I was working, we even came across counterfeit soap bars !!! Criminals were importing soap bars (were really soap) and passing them off as name brand soaps with antibacterial ingredients, and...
Forum: Im Looking For . . . 12-31-2020, 01:48 PM
Replies: 10
Views: 135
Posted By Cusser
Just wondering: where do these jacks and rods run...

Just wondering: where do these jacks and rods run off to????????????
Forum: General Discussion 12-31-2020, 01:46 PM
Replies: 9
Views: 334
Posted By Cusser
I had the engine on my 1988 Mazda B2200 truck...

I had the engine on my 1988 Mazda B2200 truck professionally rebuilt in Feb. 2020. The truck ran fine, but it had started smoking pretty bad as well as leaking oil, 220K miles; I was adding oil each...
Forum: Hardbody Forum (D21) 12-23-2020, 01:33 PM
Replies: 18
Views: 273
Posted By Cusser
I've used a CarQuest rebuilt starter in my '98...

I've used a CarQuest rebuilt starter in my '98 Frontier for about 15 years now.
Forum: Hardbody Forum (D21) 12-23-2020, 01:32 PM
Replies: 7
Views: 174
Posted By Cusser
I just made similar for my old VW, see this: ...

I just made similar for my old VW, see this:


Two weeks ago I noticed that my 20+ year-old lifetime warrantied Autozone brake master cylinder was leaking, saw fluid on VW pan underside and under...
Forum: Suspension 12-20-2020, 02:48 PM
Replies: 4
Views: 91
Posted By Cusser
On most vehicles, the tie rods will have one end...

On most vehicles, the tie rods will have one end threaded RH and one threaded LH, so each tie rod can be rotated to shorten or lengthen it to adjust the front end toe. So tie rod ends come in LH and...
Forum: General Discussion 12-20-2020, 02:45 PM
Replies: 35
Views: 554
Posted By Cusser
Live in a small town in America, like in the...

Live in a small town in America, like in the Lifetime Christmas movies !!!
Forum: General Discussion 12-19-2020, 03:09 PM
Replies: 35
Views: 554
Posted By Cusser
I'd like to see Covid end so I could go out of...

I'd like to see Covid end so I could go out of state to visit my former girlfriend
https://i.imgur.com/LFbXgtL.jpg



In the meantime we'll do some painting.
https://i.imgur.com/ptoexbQ.png
Forum: Engine and Drivetrain 12-14-2020, 03:52 PM
Replies: 6
Views: 134
Posted By Cusser
Spray some aerosol starting fluid into the air...

Spray some aerosol starting fluid into the air cleaner or carb, try to start, do this a few times. If it runs for a few seconds then quits out, you have a fuel delivery issue, start there. If it...
Forum: Engine and Drivetrain 12-05-2020, 02:55 PM
Replies: 12
Views: 231
Posted By Cusser
The power steering hose on my '98 Frontier tends...

The power steering hose on my '98 Frontier tends to leak a little there; I've replaced the clamps, and I check/add fluid every 2 months. At 253K, my PS pump is still factory, and not worth me...
Forum: Engine and Drivetrain 12-04-2020, 01:38 PM
Replies: 12
Views: 231
Posted By Cusser
Here's my own experience, with '98 and 2004...

Here's my own experience, with '98 and 2004 Frontiers with 4-cylinder engines:
I also use Gates/CarQuest 7350 instead of the 7355, as 7355 did not allow for correct amount of adjustment. I've never...
Forum: Hardbody Forum (D21) 12-02-2020, 01:20 PM
Replies: 5
Views: 111
Posted By Cusser
I would tap slightly larger if possible, and...

I would tap slightly larger if possible, and might even consider an "SAE" sie instead of metric. To stay metric, just drill/tap and use a solid threaded insert, I like those better than helicoils,...
Forum: Hardbody Forum (D21) 12-01-2020, 02:58 PM
Replies: 4
Views: 117
Posted By Cusser
dylanaguon...

dylanaguon (http://www.infamousnissan.com/forum/member.php?u=16305) wrote: "Is it Normal"


Unfortunately, it's quite normal for folks to post with titles that are nonspecific and ignore the real...
Forum: Engine and Drivetrain 11-25-2020, 01:42 PM
Replies: 1
Views: 118
Posted By Cusser
Same happened on my daughter's '98 Pathfinder, on...

Same happened on my daughter's '98 Pathfinder, on the Interstate. I had replaced her faulty distributor a year before with $85 one from Ebay retailer with 10-year warranty.


Anyway, Pathfinder...
Forum: Hardbody Forum (D21) 11-21-2020, 12:51 PM
Replies: 10
Views: 238
Posted By Cusser
more like EXACTLY two revolutions of the...

more like EXACTLY two revolutions of the crankshaft to one revolution of the camshaft for 4-stroke engines
Forum: General Discussion 11-15-2020, 02:11 PM
Replies: 36
Views: 758
Posted By Cusser
1. Always make sure to bleed ALL the air out of...

1. Always make sure to bleed ALL the air out of the cooling system. This might require parking on an uphill, or jacking up the front of the truck.


2. For the record, I run a 195F thermostat...
Forum: General Discussion 11-14-2020, 01:05 PM
Replies: 3
Views: 134
Posted By Cusser
I don't know about an '87. But I ALWAYS...

I don't know about an '87.

But I ALWAYS would hook up the cables MYSELF !!!
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 08:33 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.