Go Back   Infamous Nissan - Hardbody / Frontier Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.08 seconds.
Search: Posts Made By: XoXSciFiGuy
Forum: Hardbody Forum (D21) Today, 03:47 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
Installed CB radio and antenna into truck. Not...

Installed CB radio and antenna into truck. Not that anyone uses CB much anymore, but when you go into the sticks and the cell phone signal is zero...sometimes you can talk someone into making an...
Forum: Hardbody Forum (D21) Today, 01:58 AM
Replies: 19
Views: 304
Posted By XoXSciFiGuy
Lucas is God, not Eric Clapton no matter what you...

Lucas is God, not Eric Clapton no matter what you may have heard. I've been using it for at least twenty years at every oil change. One quart IN every oil change, fill the rest with oil, run for a...
Forum: Hardbody Forum (D21) Today, 01:49 AM
Replies: 2
Views: 23
Posted By XoXSciFiGuy
What HE said... If its the instrument panel,...

What HE said...

If its the instrument panel, what does the gauge do? If it doesn't move, just STUCK, sometimes the problem is that the needle is dragging against the back of the panel. A couple of...
Forum: Hardbody Forum (D21) 08-16-2018, 10:25 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
Deerhurst says in part: Ask your...

Deerhurst says in part:



Ask your insurance company if they are raising rates on EVERYBODY due to the natural disasters (flood in Texas, etc) they have had to cover. I was arranging new...
Forum: Hardbody Forum (D21) 08-15-2018, 07:59 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
I think they might mean that 'motor' in your air...

I think they might mean that 'motor' in your air cleaner. Try spraying some WD40 into it.

Lugnuts? Oh, brother. At least you didn't shear off the lug nuts on your way back to that shop...
Forum: Hardbody Forum (D21) 08-15-2018, 05:25 AM
Replies: 19
Views: 304
Posted By XoXSciFiGuy
There is an old trick that can help determine the...

There is an old trick that can help determine the difference. You cut off a length of broomstick to about 18 inches long, flat on both ends, and then start the engine. Stick that in your ear....
Forum: Hardbody Forum (D21) 08-14-2018, 09:21 AM
Replies: 17
Views: 261
Posted By XoXSciFiGuy
You may want to consider going into the 'Not too...

You may want to consider going into the 'Not too big or complicated Nissan classic part business', offering up a few hard to find parts for Nissans on eBay. Maybe recruit some suggestions first on...
Forum: Hardbody Forum (D21) 08-14-2018, 09:13 AM
Replies: 19
Views: 304
Posted By XoXSciFiGuy
Damn. This is a real problem for Caseyfk....

Damn. This is a real problem for Caseyfk. Look...I know this can be costly, but have you considered just going Nissan factory on a new oil pump and chain setup? At least the chain maybe, and then...
Forum: Hardbody Forum (D21) 08-14-2018, 09:01 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
You should arrange to be there when they pull...

You should arrange to be there when they pull that wheel and figure out what's wrong. You might need to actually SEE this.
Forum: Hardbody Forum (D21) 08-13-2018, 09:30 AM
Replies: 17
Views: 261
Posted By XoXSciFiGuy
A 1996? This I like. Straight injection and the...

A 1996? This I like. Straight injection and the OBD2 diagnostic system.

Get yourself a code reader at Amazon....
Forum: Hardbody Forum (D21) 08-13-2018, 09:19 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
Spent $38 (tax included) at Advance Auto Parts on...

Spent $38 (tax included) at Advance Auto Parts on the stuff below. Five buck Speed Perk discount included (cause I spent at least fifty bucks LAST purchase) plus 15% no-memorizing-the-code discount. ...
Forum: Hardbody Forum (D21) 08-11-2018, 05:45 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
LOL you are just incorrigible..nice pic though. ...

LOL you are just incorrigible..nice pic though.

Nothing much on the truck today, but a totally wacko thing happened in Seattle a few hours ago. A mechanic (described as 'suicidal' by authorities)...
Forum: Hardbody Forum (D21) 08-09-2018, 11:34 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
Took my truck to Bonney Lake, WA and shot a video...

Took my truck to Bonney Lake, WA and shot a video on the 'DB Cooper' case, fighting through the wind, traffic noise, and 92 degree heat.

Kyle, myself, and one other guy are already planning a...
Forum: Hardbody Forum (D21) 08-09-2018, 11:23 AM
Replies: 6
Views: 92
Posted By XoXSciFiGuy
Your stock Nissan alternator should easily be...

Your stock Nissan alternator should easily be able to handle a full-normal electrical load. Fifty amps, seventy amps or whatever. Fifty will run four vacuum cleaners at the same time.

If the belt...
Forum: Hardbody Forum (D21) 08-08-2018, 11:42 AM
Replies: 19
Views: 304
Posted By XoXSciFiGuy
Casey says in part: You will probably...

Casey says in part:



You will probably have to go into the front cover one last time. If those parts are good, you can re-use them. But here's the problem:

Those bolts holding down the...
Forum: Hardbody Forum (D21) 08-08-2018, 11:35 AM
Replies: 38
Views: 443
Posted By XoXSciFiGuy
I have read all the posts. Pull your dipstick,...

I have read all the posts. Pull your dipstick, see if there is any yellow or white crap on it.

Pull your radiator cap when the engine is cold. Run your finger around the inside of the cap and in...
Forum: Hardbody Forum (D21) 08-08-2018, 11:30 AM
Replies: 6
Views: 92
Posted By XoXSciFiGuy
Start the engine normally with every single...

Start the engine normally with every single accessory OFF.

Turn on EVERYTHING as quickly as you can, all lights, accessories, blast your stereo, dome light, shove in the cigarette lighter, etc.
...
Forum: Hardbody Forum (D21) 08-06-2018, 07:14 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
I feel for you, and probably everyone else on...

I feel for you, and probably everyone else on this site. Look, it aint much but I have some ideas.

1) Make a posting to Craigslist with pictures of the truck if you have them. Title the post...
Forum: Hardbody Forum (D21) 08-06-2018, 07:02 AM
Replies: 19
Views: 150
Posted By XoXSciFiGuy
The only references I have ever seen to this...

The only references I have ever seen to this light problem is that the ECM is somehow going bad. Who knows? Circuit board stuff...many years gone by since it was installed. It's possible the ECM is...
Forum: Hardbody Forum (D21) 08-05-2018, 10:17 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
Yeah, I can believe it. But you would have gotten...

Yeah, I can believe it. But you would have gotten more with a king cab. :)
Forum: Hardbody Forum (D21) 08-05-2018, 10:14 AM
Replies: 9
Views: 115
Posted By XoXSciFiGuy
Solutions: Replace starter. And don't bother...

Solutions:

Replace starter. And don't bother with those cheapie, rebuilt, remanufactured, China-shipped, junk units. GO OEM. Go brand new American-built.

I don't want to knock on Chinese stuff...
Forum: Hardbody Forum (D21) 08-04-2018, 06:14 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
Old Grey Beast says in part: You know...

Old Grey Beast says in part:



You know what works REALLY good on this? (I was the warehouse manager for a major carpet company in another life)

Get some waterproof carpet pad. It's usually...
Forum: Hardbody Forum (D21) 08-02-2018, 09:02 AM
Replies: 31
Views: 3,592
Posted By XoXSciFiGuy
PCV valves are not only rugged, but they are...

PCV valves are not only rugged, but they are simple. You can often fix them by removing the hose and just spraying Gumout into the valve. In and out...that's all they have to do.
Forum: Hardbody Forum (D21) 08-02-2018, 08:58 AM
Replies: 17,702
Views: 1,280,980
Posted By XoXSciFiGuy
Are you sure it just isn't sticking? Nissan...

Are you sure it just isn't sticking? Nissan needle gauges have been known to do that after being exposed repeatedly to excessive heat inside the cab with the windows rolled up. It happens most...
Forum: Hardbody Forum (D21) 08-02-2018, 08:53 AM
Replies: 8
Views: 148
Posted By XoXSciFiGuy
If you get out the crap and the rust completely,...

If you get out the crap and the rust completely, or close, the undercoating alone should work fine. You start spraying primer all over under there, it could get on parts it really shouldn't, like...
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 12:22 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.